2000 Jeep Cherokee Drivers Door Window Stuck Down

When the door panel is off and the switch is manipulated then it works for almost 2 or 3 days and then again nothing works.

2000 jeep cherokee drivers door window stuck down. The window will go down but not up and will only respond to the passenger front button and not the master button on the driver side. Among the windows the remote door lock mirror and light does not work at all. This leads me to believe that it is not the motor this time. The drivers side window is stuck open again.

If it works ok now the window motor is. You will need to hold the window up once you remove the screws of the regulator mechanism so that the window does not fall off the regulator mechanism. This video shows how to fix the power window issue on 97 01 jeep cherokee the correct way. It is not stuck in the tracks as it moves front to back and side to side in its channel.

Have a 2000 grand cherokee. So the same problem reemerged on the same window. Get inside the car and open the door as you are holing the window switch down slam the door shut a few times sometimes this will jar the window motor loose if it is stuck. Drive the glass into the full up position by pulling up on the window switch to its second detent manual mode and holding switch until the glass is fully closed.

Get two pieces of wood. The passenger front window will not go up. Not just by jumping a wire in the kick panel that disables the loc. Same issue using both the front and rear window switches.

The motor sounds and by the partial movement appears to be working properly. Window rolled down but won t come back up. Disconnect the window from the motor. I have a problem with my 2000 jeep cherokee.

I purchased a brand new motor and installed it but the same problem is occuring. If the window goes up but not down most likely the switch. Drive the glass to the full down position by pushing down on depress the window. For some reason the leads are not switching polarity.

Actually moves up and down a little bit. The alarm can not be activated. Meter d the leads to the motor and i m getting 12v rolling down but not rolling up. Get 1 2 pieces of wood 1 foot long is fine that will serve as braces for holding the window in place from the inside of the door you can also use painter s tape.

The drivers switch is the master switch and not like the others. It will go down but not up.